Did Incoming Signaling; T-1 Incoming Signaling - Vodavi STARPLUS Triad 1 System Programming Manual

3-40

DID Incoming Signaling

Programming Steps
There are 2 types of DID Signaling available for DID Trunks. To change the
type of signaling:
1. Press the DID INCOMING SIGNALING flexible button (FLASH 41,
2. Enter a 0 or 1 on the dial pad.
3. Press the HOLD button to save the entry. A confirmation tone is heard
Description
The DID Incoming Signal option allows the installer to determine the
type of incoming signaling used by all T-1 trunks in the system. By
default, the type of DID Incoming Signaling is set for DTMF.

T-1 Incoming Signaling

Programming Steps
There are two types of T-1 Signaling available for T-1 Trunks. To change
the type of signaling:
1. Press the T1 INCOMING SIGNALING flexible button (FLASH 41,
Button #5) for programming the type of DID signaling desired.
The following message is shown on the display phone:
D ID IN C SIG N ALIN G
D TMF
[0] = Dial Pulse
[1] = DTMF
and the display updates.
Button #6) for programming the type of T-1 signaling desired. The
following message is shown on the display phone:
T1 IN C SIG N AL
D TMF
Miscellaneous CO Parameters
0- 1
0- 1