Table of Contents
Advertisement
Miscellaneous CO Parameters
T-1 Collect Timer
1. Press the T-1 COLLECT TIMER flexible button (FLASH 40, Page C,
2. Enter a valid number on the dial pad which corresponds to 010–200
3. Press the HOLD button to save the entry. A confirmation tone is heard
Description
The T-1 Collect Timer is only used when the T-1 Incoming Signaling is set
for dial pulse. This is a time-out timer that looks at the incoming digits
one digit at a time.
If a second digit isn't detected within the 150ms, the telephone system
attempts to process that digit. If a second digit is detected, the system
waits 150ms to see if a third digit is received. Otherwise, the telephone
system attempts to process the two digits already received. This process
continues until no additional digits are received and the time-out timer
expires.
By default, the T-1 Collect Timer is set for 150 milli-seconds and is variable
from 100ms to 2.0 seconds.
Miscellaneous CO Parameters
Programming Steps
If the system is in the programming mode, continue using the program
codes. If starting to program here, enter the programming mode first.
1. Press FLASH and dial [41]. The following message displays:
Button #10). The following message is shown on the display phone:
T1 COLL ECT TIM ER
01 5
(100 ms to 2.0 seconds).
and the display updates.
CO F EATU RE S
EN TE R B U TTON N UM BE R
0 10- 20 0
3-37
Advertisement
Table of Contents
