Table of Contents
Advertisement
Page A Introduction
Forced Least Cost Routing (LCR)
Programming Steps
1. Press the FORCED LCR flexible button (FLASH 50, Page A,
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard.
Description
Stations may be forced to place outgoing CO calls by use of LCR (dial [9])
to access an outside line. This lets the system administrator control
dialing patterns and lines used for outgoing CO calls. This can be
enabled/disabled on a per-station basis for additional flexibility and
control. Forced LCR is optional (disabled) for all stations, and eliminates
access to all other line groups.
ACD Supervisor Monitor with Barge-In
Programming Steps
1. Press the SUPV BARGE-IN flexible button (FLASH 50, Page A,
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
Button #11). The following message displays:
FOR CE LCR
D ISA BLE D
[0] = Disabled
[1] = Enabled
Button #12). The following message displays:
ACD SU PV B AR G E IN
D ISA BLE D
[0] = Disabled
[1] = Enabled
0- 1
0- 1
4-11
Advertisement
Table of Contents
