Table of Contents
Advertisement
4-30
Line Group Access - Station
Programming Steps
1. Press the CO LINE GROUP ACCESS flexible button (FLASH 50, Page B,
2. To add a Line Group, enter a valid number (00, or 01–23) to designate
3. To delete a Line Group, enter a valid number (00, or 01-23), press 0,
Description
A station can access any combination of outside line groups, or a station
may not be allowed access to outside lines. CO line groups are used
primarily by single line telephones or for flexible buttons assigned as
pooled group buttons on a Key Telephone. By default, stations are
allowed access to Group 1.
LCR Class of Service (COS)
Programming Steps
1. Press the LCR COS flexible button (FLASH 50, Page B, Button #9).
Button #8). The following message displays:
LIN E GR OU P A CC ESS
1
the outside line groups that the station can access, press 1, and then
press HOLD to save the entry. A confirmation tone is heard and the
display updates.
00+1+HOLD = No Access (911 calls are blocked unless 911 Feature
is active).
01+1+HOLD = Access to Group 1 by dialing Code 9 or 801(Code 800
if 911 Feature is active).
Users access Line Groups 2-23 by dialing 802-823, respectively.
and then press HOLD. A confirmation tone is heard and the display
updates.
The following message displays:
LCR CLA SS OF SE R VIC E
0
Page B Introduction
1-2 3
0- 6
Advertisement
Table of Contents
