3-72
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard and the
4. Continue to program Bipolar Variations Alarm parameters using the
Description
Excessive Bipolar Violations (BPV) are declared when a T-1 Trunk card
detects a BPV rate in excess of 1x10
Bipolar Variations are enabled at all T-1 trunks.
Frame Slip Alarm
Programming Steps
1. Press FRAME SLIP flexible button (FLASH 47, Button #6). Button #6
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD button to save entry. A confirmation tone is heard and
4. Continue to program the Frame Slip Alarm parameters using steps
Description
When a Frame Slip or change in frame alignment is detected, the T-1
Trunk card freezes all incoming signaling states and realigns the receive
buffer. If all alarm conditions are clear, signaling states are released and
normal operation resumes. By default, Frame Slip is enabled on T-1
trunks.
[0] = Disabled
[1] = Enabled
display updates.
steps in this section for Clearing the alarm, Minor alarm, Major alarm,
Time Period, and Attendant display.
and Button #11 LEDs are lit steady. The following message displays:
SLIP
EN AB LE D
[0] = Disabled
[1] = Enabled
the display updates.
provided in this section for Clearing the alarm, Minor alarm, Major
alarm, Time Period and Attendant display.
T-1 Alarm Programming
+6
errors in 1000 seconds. By default,
0- 1