Table of Contents
Advertisement
Page A Introduction
Privacy
Programming Steps
1. Press the PRIVACY flexible button (FLASH 40, Page A, Button #5).
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard.
Disabling Privacy Function
The system can be programmed to eliminate CO Line Privacy, which
allows another station to join existing outside line conversations as
follows:
[0] = Disabled
[1] = Enabled
P RIV ACY
EN AB LE D
Disabling the privacy feature may be limited by federal, state or
local law, so check the relevant laws in your area before disabling
privacy.
Stations must have a direct CO line appearance to join CO line
conversations in progress.
A station must also have Privacy disabled before the system allows
that station to enter an existing conversation.
A programmed warning tone is presented to both parties prior to
actual cut-through (Flash 06, Button 1).
Up to seven other stations may join an existing conversation.
The station joining the call receives a solid red LED indication.
By default, Privacy is enabled for all CO Lines.
0- 1
3-7
Advertisement
Table of Contents
