Initialize Co Line Attributes; Co Line Attribute Defaults - Vodavi STARPLUS Triad 1 System Programming Manual

Introduction

Initialize CO Line Attributes

Programming Steps
1. Press the CO LINE ATTRIBUTES flexible button (FLASH 80,
2. Press the HOLD button. A confirmation tone is heard.
Description
The CO Line parameters may be initialized setting all data fields to their
original, default values. The following data fields are returned to their
default value upon initializing the CO Line Attributes.
Program
Code Button
FLASH 40
PAGE A
Button #2). The following message displays:
IN ITIA LIZ E CO
P RE SS HO LD
Table 11-2: CO Line Attribute Defaults
Flex
1 DTMF/Dial Pulse Programming
2 CO/PBX Programming
3 UNA Programming
4 DISA CO-to-CO (Per CO Line)
5 Privacy
6 Loop Supervision Programming
7 DISA Programming
8 CO Line Group Programming
9 Class of Service (COS) Programming
10 CO Line Ringing Assignments
11 CO Line Identification Display
12 CO Direction
13 Display Ring Assignments
14 DID/TIE Signal Type
15 911 Trunk
LIN ES
Features
11-9
Default Value
(after initialization)
DTMF
CO
Enabled
Enabled
Enabled
4=400 ms
None
Group 1
COS 1
(blank)
Line XXX
Incoming/Outgoing
None
Wink
Disabled