Table of Contents
Advertisement
2-44
VMID Station Numbers
Programming Steps
1. Press VMID STATION button (FLASH 06, Button #15). The following
2. Press HOLD to save the entry. A confirmation tone is heard.
Description
The VMID Station Numbers feature must be used after changing station
numbers with the Flexible Numbering feature. Voice Mail ID numbers will
be changed to match current station numbers once HOLD is pressed.
(Eliminates need for technician to program individual VMID numbers.)
Programmable Flash Rates
Programming Steps
If the system is in the programming mode, continue using the program
codes. If starting to program here, enter the programming mode.
Description
This section describes the procedures and steps necessary to program
the Flash Rates in the Flash Rates Programming area. The buttons on the
digital telephone are shown in the following illustration:
message displays:
V MID SAME AS STA #
P RE SS H OLD
This feature should be accomplished after the flexible numbers are
assigned. Implementing this feature could cause the VM box numbers to
be re-programmed.
Press FLASH and dial [07]. The following message displays:
SY ST EM FLAS H R ATES
EN TE R B U TTON N UM BE R
VMID Station Numbers
Advertisement
Table of Contents
