Table of Contents
Advertisement
Page A Introduction
Privacy (Per Station)
Programming Steps
1. Press the PRIVACY flexible button (FLASH 50, Page A, Button #5).
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard.
For Single Line Telephones:
1. Enter a 0 or 1 on the dial pad to enable/disable the Camp-On feature.
2. Press HOLD to save the entry. A confirmation tone is heard.
Description
The system provides privacy on all communications in the system which
prevents other stations from accidentally entering an existing
conversation. However, the system provides the ability for a station to
join an existing outside CO line conversation (on a per station basis). Each
station can be granted the privilege to join an existing CO line
conversation by simply pressing the CO line button of a CO line in use.
Privacy on an SLT can be useful in situations where a modem is using the
SLT port for data transmission.Disabling this feature lets data transfer
proceed without being interrupted with a Camp On tone. Both the
station and the CO Line must have Privacy disabled before the system
allows cut-through.
The following message displays:
PR IVA CY
EN AB LED
[0] = Disabled
[1] = Enabled
Disabling the privacy feature may be limited by federal, state, and
local law, so check the relevant laws in your area before disabling
privacy.
[0] = No Camp-On is allowed
[1] = Camp-On is allowed
If Privacy is disabled and a station joins an existing call, a
programmable warming tone is presented to both parties prior to
actual cut-through.
0- 1
4-7
Advertisement
Table of Contents
