General Wireless Lan Screen: Wpa-Psk; Figure 48 Network > Wireless Lan > General > Wpa-Psk; Table 36 Network > Wireless Lan > General > Static Wep; Table 37 Network > Wireless Lan > General > Wpa-Psk - ZyXEL Communications P-870HW-I Series User Manual

The following table describes the labels in this screen.
Table 36 Network > Wireless LAN > General > Static WEP
LABEL
Security Mode
WEP Key

6.4.3 General Wireless LAN Screen: WPA-PSK

Use this screen to enable and configure WPA-PSK encryption in your wireless network. To
open this screen, click Network > Wireless LAN, and set Security Mode to WPA-PSK.
Figure 48 Network > Wireless LAN > General > WPA-PSK
The following table describes the labels in this screen.
Table 37 Network > Wireless LAN > General > WPA-PSK
LABEL
Security Mode
Pre-Shared
Key
ReAuthenticati
on Timer
Chapter 6 Wireless LAN
DESCRIPTION
Select Static WEP.
Enter the key you want to use. You can enter the key using printable ASCII characters
or hexadecimal (0-9, A-F, a-f) characters. The ZyXEL Device and the wireless
stations must use the same WEP key.
If you want to use a 64-bit WEP key, enter 5 printable ASCII characters or 10
hexadecimal characters.
If you want to use a 128-bit WEP key, enter 13 printable ASCII characters or 26
hexadecimal characters. A 128-bit WEP key is more secure than a 64-bit WEP key.
DESCRIPTION
Select WPA-PSK.
Type a pre-shared key from 8 to 63 ASCII characters (including spaces and symbols).
The key is case-sensitive.
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds.
P-870HW-I1 User's Guide
99