Nat Server Configuration; Figure 176 Menu 15.2: Nat Server Setup; Table 134 Menu 15.2: Nat Server Setup - ZyXEL Communications P-870HW-I Series User Manual

Figure 176 Menu 15.2: NAT Server Setup

The following table describes the labels in this menu.

Table 134 Menu 15.2: NAT Server Setup

FIELD
Default Server
Rule
Act.
Start Port
End Port
IP Address
Select Command
Select Rule

29.5 NAT Server Configuration

Use this menu to configure port forwarding rules for servers behind the ZyXEL Device. See
Chapter 10 on page 137
forwarding rules in menu 15.2.
Chapter 29 NAT Setup
Menu 15.2 - NAT Server Setup
Default Server: 0.0.0.0
Rule Act. Start Port
------------------------------------------------------
001 No 0
002 No 0
003 No 0
004 No 0
005 No 0
006 No 0
007 No 0
008 No 0
009 No 0
010 No 0
Select Command= None
DESCRIPTION
Enter the IP address of the server to which the ZyXEL Device should forward
packets for ports that are not specified in the section below or in menu 24.11
(remote management). Enter 0.0.0.0 if you want the ZyXEL Device to discard
these packets instead.
This field is a sequential value, and it is not associated with a specific rule. The
sequence is important, however. The ZyXEL Device checks each active rule in
order, and it only follows the first one that applies.
This field displays whether or not this rule is active.
This field displays the beginning of the range of port numbers forwarded by this
rule.
This field displays the end of the range of port numbers forwarded by this rule.
If it is the same as the Start Port, only one port number is forwarded.
This field displays the IP address of the server to which packet for the selected
port(s) are forwarded.
In the Select Command field, press the [SPACEBAR] to select what change
you would like to make. For some actions, enter the rule number in the Select
Rule field to specify on which rule you would like to apply the action.
for background information. To open this menu, select one of the port
P-870HW-I1 User's Guide
End Port IP Address
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
Select Rule= N/A
283