General Wireless Lan Screen: Wpa2-Psk; Figure 53 Network > Wireless Lan > General > Wpa2-Psk; Table 42 Network > Wireless Lan > General > Wpa2-Psk - ZyXEL Communications P-870HW-I Series User Manual

P-870HW-I1 User's Guide
Table 41 Network > Wireless LAN > General > 802.1x + No WEP (continued)
LABEL
Accounting
Server
Active
IP Address
Port Number
Shared Secret

6.4.8 General Wireless LAN Screen: WPA2-PSK

Use this screen to enable and configure WPA2-PSK encryption in your wireless network. To
open this screen, click Network > Wireless LAN, and set Security Mode to WPA2-PSK.
Figure 53 Network > Wireless LAN > General > WPA2-PSK
The following table describes the labels in this screen.
Table 42 Network > Wireless LAN > General > WPA2-PSK
LABEL
Security Mode
WPA
Compatible
Pre-Shared
Key
ReAuthenticati
on Timer
106
DESCRIPTION
These settings are optional.
Select this to enable user accounting through an external authentication server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. You need not change this
value unless your network administrator instructs you to do so.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the ZyXEL Device. The key must be the
same on the external accounting server. The key is not sent over the network.
DESCRIPTION
Select WPA2-PSK.
Select this if the ZyXEL Device should be able to handle WPA-PSK and WPA2-PSK,
depending on the abilities of each wireless station. This requires additional
processing and may reduce throughput.
Type a pre-shared key from 8 to 63 ASCII characters (including spaces and symbols).
The key is case-sensitive.
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds.
Chapter 6 Wireless LAN