Ip Routing Policy Setup - ZyXEL Communications P-870HW-I Series User Manual

P-870HW-I1 User's Guide
Table 160 Menu 25.1: IP Routing Policy Setup (continued)
FIELD
Criteria
IP Protocol
Type of Service
Precedence
Packet Length
Len Comp
Source
addr start / end
port start / end
Destination
addr start / end
port start / end
Action
Gateway addr
Type of Service
Precedence
Log
Edit policy to packets
received from

37.6 IP Routing Policy Setup

Use this menu to specify the ports from which traffic comes to which the policy routes apply.
To open this menu, select Yes in Edit policy to packets received from in menu 25.1.
342
DESCRIPTION
Enter a number that represents an IP layer 4 protocol, for example, UDP=17,
TCP=6, ICMP=1 and Don't care=0.
Prioritize incoming network traffic by choosing from Don't Care, Normal, Min
Delay, Max Thruput or Max Reliable.
Precedence value of the incoming packet. Press [SPACE BAR] and then
[ENTER] to select a value from 0 to 7 or Don't Care.
Type the length of incoming packets (in bytes). The operators in the Len Comp
(next field) apply to packets of this length.
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
Less, Greater, Less or Equal or Greater or Equal.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not Matched.
Enter the IP address of the gateway to which the ZyXEL Device forwards the
packet. The gateway is an immediate neighbor of your ZyXEL Device and must
be on the same subnet as the ZyXEL Device, if it is on the LAN, or the IP
address of a remote node, if it is on the WAN. Enter 0.0.0.0 to specify the
default gateway.
Set the new TOS value of the outgoing packet. Prioritize incoming network
traffic by choosing Don't Care, Normal, Min Delay, Max Thruput, Max
Reliable or Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't
Care.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
If you want to specify the ports from which traffic comes to which the policy
applies, press [SPACE BAR] to select Yes and press [ENTER]. Menu 25.1.1
appears.
Chapter 37 IP Routing Policy Setup