Example Xmodem Configuration Upload Using Hyperterminal; Figure 218 Menu 24.7.2 As Seen Using The Console Port; Figure 219 Example Xmodem Upload - ZyXEL Communications P-870HW-I Series User Manual

Figure 218 Menu 24.7.2 as seen using the Console Port

Menu 24.7.2 - System Maintenance - Upload System Configuration File
2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.
3 Enter "atgo" to restart the ZyXEL Device.

35.4.10 Example Xmodem Configuration Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 219 Example Xmodem Upload

After the configuration upload process has completed, restart the ZyXEL Device by entering
"atgo"
Chapter 35 System Maintenance 24.5 - 24.7
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)
P-870HW-I1 User's Guide
Type the configuration
file's location, or
click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
331