General Wireless Lan Screen - ZyXEL Communications EMG3425-Q10A User Manual

Number) in the devices. Then, they connect and set up a secure network by themselves. See how
to set up a secure wireless network using WPS in the

9.2 General Wireless LAN Screen

Use this screen to configure the SSID and wireless security of the wireless LAN.
Note: If you are configuring the EMG3425-Q10A from a computer connected to the
wireless LAN and you change the EMG3425-Q10A's SSID, channel or security
settings, you will lose your wireless connection when you press Apply to confirm.
You must then change the wireless settings of your computer to match the
EMG3425-Q10A's new settings.
Click Network > Wireless LAN 2.4G/5G to open the General screen.
Figure 33 Network > Wireless LAN 2.4G/5G > General
The following table describes the general wireless LAN labels in this screen.
Table 19 Network > Wireless LAN 2.4G/5G > General
LABEL
Wireless LAN
Name (SSID)
Hide SSID
Chapter 9 Wireless LAN
DESCRIPTION
Select Enable to activate the 2.4GHz and/or 5GHz wireless LAN. Select Disable to turn it
off.
Note: You can enable or disable both 2.4GHz and 5GHz wireless LANs by using the WIFI
button located on the side panel of the EMG3425-Q10A.
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
EMG3425-Q10A User's Guide
73
Section 6.2 on page 38.