Figure 191 Filtering LAN Traffic
30.6.2 Applying Remote Node Filters
Go to menu 11.5 (shown below – note that call filter sets are only present for PPPoE
encapsulation) and enter the number(s) of the filter set(s) as appropriate. You can cascade up
to four filter sets by entering their numbers separated by commas. The ZyXEL Device already
has filters to prevent NetBIOS traffic from triggering calls, and block incoming telnet, FTP
and HTTP connections.
Figure 192 Filtering Remote Node Traffic
Use this menu to set up your Internet connection, input and output filter sets for the WAN port,
advanced features for the WAN port, or a backup gateway.
30.7 Remote Node Profile
Use this menu to set up your Internet connection. See
information. To open this menu, enter 11 in the main menu.
Chapter 30 Filter Setup
Menu 3.1 - LAN Port Filter Setup
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Press ENTER to Confirm or ESC to Cancel:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
P-870HW-I1 User's Guide
Chapter 7 on page 119
for background
301