General Wireless Lan Screen: No Security; Figure 45 Network > Wireless Lan > General; Table 34 Network > Wireless Lan > General - ZyXEL Communications P-870HW-I Series User Manual

To open this screen, click Network > Wireless LAN.
Figure 45 Network > Wireless LAN > General
The following table describes the general wireless LAN labels in this screen.
Table 34 Network > Wireless LAN > General
LABEL
Wireless Setup
Enable
Wireless LAN
Name(SSID)
Hide SSID
Channel
Selection
Security
Apply
Reset

6.4.1 General Wireless LAN Screen: No Security

Use this screen to allow wireless stations to communicate with the access points without any
data encryption.To open this screen, click Network > Wireless LAN, and set Security Mode
to No Security.
Note: If you do not enable any wireless security on your ZyXEL Device, your network
is accessible to any wireless networking device that is within range.
Chapter 6 Wireless LAN
DESCRIPTION
Click the check box to activate wireless LAN.
Enter the name of the wireless network. The name is called the Service Set IDentity
(SSID). Every wireless client in the same wireless network must use the same SSID.
Note: If you are using the wireless network to connect to the ZyXEL
Device from a computer and you change this setting, you will
lose your wireless connection when you press Apply to
confirm. You must change the wireless settings of your
computer to match the ZyXEL Device's new settings.
Select this check box to hide the SSID so a station cannot get the SSID through
scanning using a site survey tool.
Set the operating frequency or channel your wireless network uses. It should be at
least five channels away from other wireless networks in the area.
This section is described in more detail below.
Click this to save your changes back to the ZyXEL Device.
Click this to reload the previous configuration for this screen.
P-870HW-I1 User's Guide
97