Firmware Upload; Configuration File Upload; Figure 213 Menu 24.7.1: System Maintenance - Upload System Firmware - ZyXEL Communications P-870HW-I Series User Manual

P-870HW-I1 User's Guide

35.4.1 Firmware Upload

FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client.
When you telnet into the ZyXEL Device, you will see the following screens for uploading
firmware and the configuration file using FTP.

Figure 213 Menu 24.7.1: System Maintenance - Upload System Firmware

To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system.
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.

35.4.2 Configuration File Upload

You see the following screen when you telnet into menu 24.7.2.
326
Menu 24.7.1 - System Maintenance - Upload System Firmware
Press ENTER to Exit:
Then type "admin" and
Chapter 35 System Maintenance 24.5 - 24.7