Static Dhcp Screen; Figure 72 Network > Dhcp Server > Static Dhcp; Table 56 Dhcp Setup - ZyXEL Communications P-870HW-I Series User Manual

Table 55 Network > DHCP Server > General (continued)
LABEL
First DNS Server
Second DNS
Server
Third DNS Server
Apply
Reset

9.3 Static DHCP Screen

Use this screen to assign static IP address to specific computers. To open this screen, click
Network > DHCP Server > Static DHCP.
Figure 72 Network > DHCP Server > Static DHCP
The following table describes the labels in this screen.

Table 56 DHCP Setup

LABEL
#
MAC Address
Chapter 9 DHCP Server
DESCRIPTION
Specify the IP addresses of a maximum of three DNS servers that the network can
use. The ZyXEL Device provides these IP addresses to DHCP clients. You can
specify these IP addresses the following ways:
From ISP - use the IP address of the corresponding DNS server specified in
Network > WAN > Advanced.
User-Defined - enter a static IP address.
DNS Relay - use the ZyXEL Device's IP address. In this case, the ZyXEL Device
finds out the IP address of the DNS server (based on RFC 1877). Then, it forwards
DNS queries from DHCP clients to this server and sends the response back to the
DHCP clients.
None - there is no second or third DNS server.
Click this to save your changes back to the ZyXEL Device.
Click this to reload the previous configuration for this screen.
DESCRIPTION
This field is a sequential value.
Enter the MAC address of the computer to which you want to assign a static IP
address.
P-870HW-I1 User's Guide
135