Table of Contents
Advertisement
Figure 52 Network > Wireless LAN > General > 802.1x + No WEP
The following table describes the labels in this screen.
Table 41 Network > Wireless LAN > General > 802.1x + No WEP
LABEL
Security Mode
ReAuthenticati
on Timer
Idle Timeout
Authentication
Server
IP Address
Port Number
Shared Secret
Chapter 6 Wireless LAN
DESCRIPTION
Select 802.1x + No WEP.
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds.
The ZyXEL Device automatically disconnects a wireless station from the wireless
network after a period of inactivity. The wireless station needs to enter the username
and password again before it can use the wireless network again. Some wireless
clients can do this automatically; some wireless clients cannot, in which case the user
has to enter the information again. In either case, there is usually a short delay while
the wireless client logs in to the wireless network again.
Enter a time interval between 10 and 9999 seconds. This value is usually smaller
when the wireless network is keeping track of how much time each wireless station is
connected to the wireless network (for example, using an authentication server). If the
wireless network is not keeping track of this information, you can usually set this value
higher to minimize the number of delays caused by logging in again.
Enter the IP address of the external authentication server in dotted decimal notation.
Enter the port number of the external authentication server. You need not change this
value unless your network administrator instructs you to do so.
Enter a password (up to 31 alphanumeric characters) to be shared between the
external authentication server and the ZyXEL Device. The key must be the same on
the external authentication server. The key is not sent over the network.
P-870HW-I1 User's Guide
105
Advertisement
Table of Contents
Troubleshooting
