Using The Ftp Command From The Dos Prompt; Figure 205 Menu 24.5: Backup Configuration - ZyXEL Communications P-870HW-I Series User Manual

Figure 205 Menu 24.5: Backup Configuration

To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "admin" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program.
in this menu to back up using TFTP), please see your router manual.

35.2.2 Using the FTP command from the DOS Prompt

1 Launch the FTP client on your computer.
2 Enter "open" and the IP address of your ZyXEL Device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested. The default is 1234.
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the ZyXEL Device to the computer, for example, "get
rom-0 config.rom" transfers the configuration file on the ZyXEL Device to your
computer and renames it "config.rom". See earlier in this chapter for more information on
filename conventions.
7 Enter "quit" to exit the FTP prompt.
Chapter 35 System Maintenance 24.5 - 24.7
Menu 24.5 - Backup Configuration
For details on backup using TFTP (note that you must remain
P-870HW-I1 User's Guide
321