Use this menu to configure your ZyXEL Device's settings for Simple Network Management
Protocol (SNMP) management. See
open this menu, enter 22 in the main menu.
Figure 195 Menu 22: SNMP Configuration
The following table describes the labels in this menu.
Table 142 Menu 22: SNMP Configuration
FIELD
Get Community
Set Community
Trusted Host
Trap
Community
Destination
Chapter 32 SNMP Configuration
C
SNMP Configuration
Chapter 16 on page 205
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
DESCRIPTION
Enter the password for incoming Get requests and GetNext requests from the
management station. The default is public and allows all requests.
Enter the password for incoming Set requests from the management station.
The default is public and allows all requests.
Enter an IP address to only allow the computer with this IP address to access
the ZyXEL Device using this service. Enter 0.0.0.0 to allow any computer to
access the ZyXEL Device using this service. This is the same field you can set
up in menu 24.11.
Type the password sent with each trap to the SNMP manager. The default is
public and allows all requests.
Type the IP address of the station to which send SNMP traps.
P-870HW-I1 User's Guide
H A P T E R
for background information. To
3 2
307