Table of Contents
Advertisement
Use this menu to set up your Internet connection. See
on page 137
Figure 164 Menu 4: Internet Access Setup
The following table describes the labels in this menu.
Table 122 Menu 4: Internet Access Setup
FIELD
ISP's Name
Encapsulation
My Login
My Password
Retype to Confirm
Idle Timeout
IP Address
Assignment
IP Address
IP Subnet Mask
Chapter 25 Internet Access Setup
Internet Access Setup
for background information. To open this menu, enter 4 in the main menu.
Menu 4 - Internet Access Setup
ISP's Name= ChangeMe
Encapsulation= PPPoE
My Login= hello
My Password= ********
Retype to Confirm= ********
Idle Timeout= 100
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address= N/A
Network Address Translation= SUA Only
DESCRIPTION
Enter the name of the ISP.
Select the type of encapsulation your ISP uses. If you select PPPoE and then
save your changes, the ZyXEL Device asks you if you want to test the settings.
The next fields are only available if your ISP uses PPPoE encapsulation.
Enter the user name provided by your ISP.
Enter the password provided by your ISP.
Enter the password again.
Enter the number of seconds the ZyXEL Device should wait while there is no
Internet traffic before it automatically disconnects from the ISP. Enter a time
interval between 10 and 9999 seconds.
Select Dynamic if your ISP did not give you a fixed (static) IP address. Select
Static if your ISP gave you a fixed (static) IP address. The next three fields are
not available if you select Dynamic.
Enter the fixed (static) IP address provided by your ISP.
This field is not available if your ISP uses PPPoE encapsulation. Enter the
subnet mask provided by your ISP.
C
H A P T E R
Chapter 7 on page 119
P-870HW-I1 User's Guide
2 5
and
Chapter 10
267
Advertisement
Table of Contents
Troubleshooting
