Otist Screen; Table 43 Network > Wireless Lan > General > Wpa2 - ZyXEL Communications P-870HW-I Series User Manual

P-870HW-I1 User's Guide
The following table describes the labels in this screen.
Table 43 Network > Wireless LAN > General > WPA2
LABEL
Security Mode
WPA
Compatible
ReAuthenticati
on Timer
Idle Timeout
Group Key
Update Timer
Authentication
Server
IP Address
Port Number
Shared Secret
Accounting
Server
Active
IP Address
Port Number
Shared Secret

6.5 OTIST Screen

Use this screen to set up and start OTIST on the ZyXEL Device in your wireless network. To
open this screen, click Network > Wireless LAN > OTIST.
108
DESCRIPTION
Select WPA2.
Select this if the ZyXEL Device should be able to handle WPA-PSK and WPA2-PSK,
depending on the abilities of each wireless station. This requires additional
processing and may reduce throughput.
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds.
The ZyXEL Device automatically disconnects a wireless station from the wired
network after a period of inactivity. The wireless station needs to enter the username
and password again before access to the wired network is allowed. Enter a time
interval between 10 and 9999 seconds.
The Group Key Update Timer is the rate at which the ZyXEL Device sends a new
group key to all clients. This process changes the WEP key on a regular basis. Enter
a time interval between 10 and 9999 seconds.
Enter the IP address of the external authentication server in dotted decimal notation.
Enter the port number of the external authentication server. You need not change this
value unless your network administrator instructs you to do so.
Enter a password (up to 31 alphanumeric characters) to be shared between the
external authentication server and the ZyXEL Device. The key must be the same on
the external authentication server. The key is not sent over the network.
These settings are optional.
Select this to enable user accounting through an external authentication server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. You need not change this
value unless your network administrator instructs you to do so.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the ZyXEL Device. The key must be the
same on the external accounting server. The key is not sent over the network.
Chapter 6 Wireless LAN