General Wireless Lan Screen - ZyXEL Communications LTE3301 Series User Manual

The types of encryption you can choose depend on the type of user authentication. (See
for information about this.)
Table 17 Types of Encryption for Each Type of Authentication
Weakest
Strongest
For example, if the wireless network has a RADIUS server, you can choose WPA or WPA2. If users
do not log in to the wireless network, you can choose no encryption, Static WEP, WPA-PSK, or
WPA2-PSK.
Usually, you should set up the strongest encryption that every wireless client in the wireless
network supports. For example, suppose the AP does not have a local user database, and you do
not have a RADIUS server. Therefore, there is no user authentication. Suppose the wireless network
has two wireless clients. Device A only supports WEP, and device B supports WEP and WPA.
Therefore, you should set up Static WEP in the wireless network.
Note: It is recommended that wireless networks use WPA-PSK, WPA, or stronger
encryption. IEEE 802.1x and WEP encryption are better than none at all, but it is
still possible for unauthorized devices to figure out the original information pretty
quickly.
Note: It is not possible to use WPA-PSK, WPA or stronger encryption with a local user
database. In this case, it is better to set up stronger encryption with no
authentication than to set up weaker encryption with the local user database.
When you select WPA2 or WPA2-PSK in your LTE3301, you can also select an option (WPA/WPA-
PSK Compatible) to support WPA/WPA-PSK as well. In this case, if some wireless clients support
WPA and some support WPA2, you should set up WPA2-PSK or WPA2 (depending on the type of
wireless network login) and select the WPA/WPA-PSK Compatible option in the LTE3301.
Many types of encryption use a key to protect the information in the wireless network. The longer
the key, the stronger the encryption. Every wireless client in the wireless network must have the
same key.
WPS
WiFi Protected Setup (WPS) is an industry standard specification, defined by the WiFi Alliance. WPS
allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Depending on the devices in your network, you can either press a
button (on the device itself, or in its configuration utility) or enter a PIN (Personal Identification
Number) in the devices. Then, they connect and set up a secure network by themselves. See how
to set up a secure wireless network using WPS in the

7.2 General Wireless LAN Screen

Use this screen to configure the SSID and wireless security of the wireless LAN.
Chapter 7 Wireless LAN
NO AUTHENTICATION
No Security
Static WEP
WPA-PSK
WPA2-PSK
LTE3301 Series User's Guide
RADIUS SERVER
WPA
WPA2
Section 4.2 on page
64
page 63
30.