Sense:average Subsection - HP ESA-E Series Programmer's Manual

Language Reference
SENSe Subsystem

SENSe:AVERage Subsection

Clear the Current Average
[:SENSe]:AVERage:CLEar
Re-start the trace averaging function.
Front Panel
Access:
none
Set the Average Count
[:SENSe]:AVERage:COUNt <integer>
[:SENSe]:AVERage:COUNt?
Specifies the number of measurements that are combined.
Factory Preset
and *RST: 100
Range: 1 to 8192
Front Panel
Access:
BW/Avg, Average On Off
Turn Averaging On/Off
[:SENSe]:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:AVERage[:STATe]?
The value of successive measurements can be combined together to
average out measurement variations.
Factory Preset
and *RST: Off
Remarks: When a measurement under the front panel
key is started, this command is turned off for video
averaging ([:SENSe]:AVERage:TYPE LPOWer). If this
command is turned on for video averaging when any of
the
MEASURE
measurement will be stopped.
Front Panel
Access:
BW/Avg, Average On Off
Type of Averaging for Measurements
[:SENSe]:AVERage:TYPE LPOWer|POWer
[:SENSe]:AVERage:TYPE?
This command selects the type of averaging to be performed.
LPOWer logarithmically averages the power of the video data (typical
5-72
key measurements are in progress, that
MEASURE
Chapter 5