HP ESA-E Series Programmer's Manual page 391

Error Messages
201 to 799: Device-Specific Errors
755
Unable to load state from register
Loading a state from an internal state register failed.
757
Unable to load user state, factory preset was
done
An attempt to perform a
Factory Preset
User Preset
760
Unable to query state
Query of state over the remote interface was
unsuccessful.
764
Unable to save file
A failure occurred while saving a file; the file was not
saved.
756
Unable to save state to register
Saving of state to an internal register failed.
753
Unable to save state to file
Saving of state to a file failed.
758
Unable to save user state
An attempt to save to the
761
Unable to set state
Attempt to set the state over the remote interface was
unsuccessful.
207
Unable to store flatness data
A failure occurred in setting the flatness data in the
internal EEROM. Contact your local Hewlett-Packard
sales and service office.
7-24
User Preset
values were used. Save a valid state into
and try again.
User Preset
failed, so the
state failed.
Chapter 7