HP ESA-E Series Programmer's Manual page 334

HP 8590-Series
Analyzers
Command(s)
ML
ML <value> [:SENSe]:POWer[:RF]:MIXer:RANGe[:UPPer] <ampl>
ML UP|DN
ML? [:SENSe]:POWer[:RF]:MIXer:RANGe[:UPPer]?
MOD
MODE
MOV
:TRACe:COPY <source_trace>,<dest_trace>
MPY
Corresponding SCPI Command(s) Description/Comments
Specifies the maximum signal level that is
applied to the input mixer for a signal that
is equal to or below the reference level.
Specifies the maximum power at the input
mixer for a signal that is equal to or below
the reference level.
The HP 8590-Series analyzer outputs data
in the format: -10. The HP ESA analyzer
outputs data in the format:
-1.00000000E+001.
Stores the remainder from the division of
source 1 by source 2 in the destination.
Returns a "0" if the mode of operation is
spectrum analysis. A number other than
"0" is returned if the operating mode (also
called "personality") is other than spectrum
analysis.
Copies the source values into the
destination. <dest_trace,<num_value>
Transfers the source trace to the
destination trace.
Source traces are: TRACE[1|2|3]
Destination traces are: TRACE[1|2|3]
Multiplies the sources, point by point, and
places the results in the destination.