HP ESA-E Series Programmer's Manual page 332

HP 8590-Series
Analyzers
Command(s)
MKRL
:CALCulate:MARKer[1]|2|3|4[:SET]:RLEVel
MKSP
:CALCulate:MARKer[1]|2|3|4[:SET]:SPAN
MKSS
:CALCulate:MARKer[1]|2|3|4[:SET]:STEP
MKSTOP
MKTBL
:CALCulate:MARKer:TABLe:STATe OFF|ON|0|1
MKTBL? :CALCulate:MARKer:TABLe:STATe?
Corresponding SCPI Command(s) Description/Comments
Sets the reference level to the amplitude
value of the active marker.
Sets the reference level to the specified
marker amplitude.
Sets the start and stop frequencies to the
values of the delta markers.
Sets the span to the value of the specified
marker frequency. The specified marker
must be in delta mode. Select the delta
marker mode with :CALCulate:MARKer
[1]|2|3|4:MODE:DELTa.
Sets the center frequency step size to the
marker frequency.
Sets the center frequency step size equal to
the specified marker frequency.
Stops the sweep at the active marker.
Turns the marker table on or off.
The HP 8590-Series analyzer outputs ON
or OFF. The HP ESA analyzer outputs 1
or 0.