HP ESA-E Series Programmer's Manual page 335

HP 8590-Series
Analyzers
Command(s)
MSI
MXM
MXMH
:TRACe:[1]|2|3:MODE MAXHold
NDB
:CALCulate:BWIDth|BANDwidth:NDB<rel_ampl>
NDB? :CALCulate:BWIDth|BANDwidth:NDB?
NDBPNT
:CALCulate:BWIDth|BANDwidth[:STATe] OFF|ON|0|1
NDBPNT? :CALCulate:BWIDth|BANDwidth[:STATe]?
Corresponding SCPI Command(s) Description/Comments
Allows you to specify the current mass
storage device as the spectrum analyzer
memory or a memory card.
Compares source 1 and source 2, point by
point, sending the greater value of each
comparison to the destination.
Updates trace elements with maximum
level detected.
Specifies the distance (in dB) from the
signal peak for the N dB points
measurement (NDBPNT).
The HP 8590-Series analyzer outputs data
in the format: -3. The HP ESA analyzer
outputs data in the format:
-3.00000000E+000.
Turns the N dB points measurement on or
off.
The HP 8590-Series analyzer outputs ON
or OFF. The HP ESA analyzer outputs 1
or 0.