HP ESA-E Series Programmer's Manual page 364

HP 8590-Series
Analyzers
Command(s)
XCH
XCH :TRACe:EXCHange <trace_1>,<trace_2>
TRA|TRB|TRC,
TRA|TRB|TRC
ZMKCNTR
ZMKPKNL
ZMKPKNR
ZMKSPAN Allows you to change the width of the zone marker.
Corresponding SCPI Command(s) Description/Comments
Exchanges traces.
Exchanges two traces, point by point.
Trace_1 choices are: TRACE[1|2|3]
Trace_2 choices are: TRACE[1|2|3]
Positions the zone marker at the specified
frequency.
Places the zone marker at the next signal
peak that is left of the current position of
the zone marker.
Places the zone marker at the next signal
peak that is left of the current position of
the zone marker.