HP ESA-E Series Programmer's Manual page 360

HP 8590-Series
Analyzers
Command(s)
TRPRST
TRSTAT
TRACe[1]|2|3:MODE?
TS
INITiate[:IMMediate]
*OPC
TVLINE
TVSFRM
TVSTND
Corresponding SCPI Command(s) Description/Comments
Sets the trace operations to their preset
values.
Returns the status of traces A, B, and C:
clear write, blank, view, minimum hold, or
maximum hold.
Traces are: TRACE[1|2|3]. TRACE1
corresponds to trace A, TRACE2
corresponds to trace B, and TRACE3
corresponds to trace C.
The HP 8590-Series analyzer returns the
format: CLRW A;BLANK B;BLANK C;.
The HP ESA analyzer returns the format:
WRIT;BLAN;BLAN. All three traces in the
HP ESA analyzer will be queried, with an
EOI after each response.
Starts and completes one full sweep before
the next command is executed.
Allows you to determine when the
spectrum analyzer has started to execute
all commands prior to and including TS.
Sets the line number of the horizontal line
of video on which to trigger.
Specifies type of video frame to trigger on.
Selects the triggering for NTSC, PAL,
PAL-M, and SECAM-L formats.