HP ESA-E Series Programmer's Manual page 44

HP ESA Status Registers
Using the Analyzer Status Registers
returned.
7
Bit Number
Standard Event Status Enable Register
The event enable register in the Standard Event Status Register lets
you choose which bits will set the summary bit (bit 5 of the Status Byte
Register) to 1. Send the command *ESE <number> where <number> is
the sum of the decimal values of the bits you want to enable. For
example, to enable bit 7 and bit 6 so that whenever either of those bits
is set to 1, the standard event status summary bit of the Status Byte
Register will be set to 1, send the command *ESE 192 (128 + 64). The
command *ESE? returns the decimal value of the sum of the bits
previously enabled with the *ESE <number> command.
2-14
6 5 4 3
*ESE <num>
*ESE?
2 1 0
ck728a
Chapter 2