HP ESA-E Series Programmer's Manual page 327

HP 8590-Series
Analyzers
Command(s)
MKDLMODE
MKF
:CALCulate:MARKer[1]|2|3|4:X <param>
MKF? :CALCulate:MARKer[1]|2|3|4:X?
MKFC
:CALCulate:MARKer[1]|2|3|4:FCOunt[:STATe]
OFF|ON|0|1
Corresponding SCPI Command(s) Description/Comments
Selects whether the marker amplitude values
are shown as relative to the reference level
(normal mode), or relative to the display line
(delta mode) when the marker table is turned
on.
Specifies the frequency value of the active
marker.
Positions the designated marker on the
assigned trace at the specified X value. The
value is in the x axis units (which is often
frequency or time).
The HP 8590-Series analyzer outputs data in
the format: 750E6. The HP ESA analyzer
outputs data in the format:
+7.50000000E+008.
Turns the marker frequency counter on or off.