HP ESA-E Series Programmer's Manual page 346

HP 8590-Series
Analyzers
Command(s)
SAVES
:MMEMory:LOAD:STATe <reg_number>,<file_name>
SAVET
SAVET TRA :MMEMory:STORe:TRACe <label>,<file_name>
SAVET TRB
SAVET TRC
SAVET LIMILINE :MMEMory:STORe:LIMit LLINe1|LLINe2, <file_name>
SAVET AMPCOR
SAVRCLF
Corresponding SCPI Command(s) Description/Comments
Saves the currently displayed instrument
state in spectrum analyzer memory. These
registers do not appear in a FILE catalog.
The only acceptable delimiter is a single
quote('). Only traces and states are
supported; limit lines and ampcor are not
supported. Use only file extensions: .TRC,
.TRB, .TRA, and .STA. A disk drive name
(C: or A:) must be included in the file name.
States and traces saved using
HP 8590-Series analyzers cannot be read
by HP ESA analyzers.
Saves the selected trace data and state
information, amplitude correction factors,
or limit-line tables in spectrum analyzer
memory. These registers are specially
mapped to named files.
HP ESA analyzers save only state
information registers *SAV and *RCK. The
only acceptable delimiter is a single
quote('). Only traces and states are
supported; limit lines and ampcor are not
supported. Use only file extensions: .TRC,
.TRB, .TRA, and .STA. A disk drive name
(C: or A:) must be included in the file name.
States and traces saved using
HP 8590-Series analyzers cannot be read
by HP ESA analyzers.
Specifies either a save or recall operation.