HP ESA-E Series Programmer's Manual page 298

HP 8590-Series
Analyzers
Command(s)
AMPLEN
ANLGPLUS
ANNOT
ANNOT ON|OFF :DISPlay:WINDow:ANNotation[:ALL] OFF|ON|0|1
ANNOT? :DISPlay:WINDow:ANNotation[:ALL]?
APB
:TRACe:MATH:ADD <destination_trace>, <source_trace1>,
<source_trace2>
AT
AT <numeric_ [:SENSe]:POWer[:RF]:ATTenuation <rel_ampl>
value>
AT AUTO [:SENSe]:POWer[:RF]:ATTenuation:AUTO ON|1
AT UP|DN
AT? [:SENSe]:POWer[:RF]:ATTenuation?
Corresponding SCPI Command(s) Description/Comments
Returns the number of frequency-amplitude
correction factors that have been entered.
Turns the Analog+ display mode on or off.
Turns the screen annotation on or off.
The HP 8590-Series analyzer returns ON or
OFF. The HP ESA analyzer returns 1 or 0.
Adds trace A to trace B and sends the result to
trace A.
Adds TRACE1 (trace A) to TRACE2 (trace B)
and sends the result to TRACE1 (trace A).
Specifies RF input attenuation.
The up/down steps are in 5 dB increments.
The up/down steps are in 5 dB increments.
The HP 8590-Series analyzer outputs data in
the format: 10. The HP ESA analyzer outputs
data in the format: +1.00000000E+001.