HP ESA-E Series Programmer's Manual page 349

HP 8590-Series
Analyzers
Command(s)
SMOOTH
SMOOTH TRA? :TRACe:MATH:SMOoth <trace>
SMOOTH TRB?
SMOOTH TRC?
:TRACe:MATH:SMOoth:POINts <integer>
SNGLS
:INITiate:CONTinuous OFF|0
SP
SP <value> [:SENSe]:FREQuency:SPAN <freq>
SP UP|DN
SP? [:SENSe]:FREQuency:SPAN?
Corresponding SCPI Command(s) Description/Comments
Smooths the trace according to the number
of points specified for the running average.
Smooths the trace according to the number
of points specified in
:TRACe:MATH:SMOoth:POINts.
Traces are: TRACe[1|2|3].
TRACE1 corresponds to trace A,
TRACE2 corresponds to trace B, and
TRACE3 corresponds to trace C.
Specifies the number of points that will be
smoothed in :TRACe:MATH:SMOoth.
Selects single-sweep mode.
Changes the total displayed frequency
range symmetrically about the center
frequency.
Set the frequency span.
The HP 8590-Series analyzer outputs data
in the format: 750000000. The HP ESA
analyzer outputs data in the format:
+750000000.