HP ESA-E Series Programmer's Manual page 339

HP 8590-Series
Analyzers
Command(s)
PEAKS
:TRACe:MATH:PEAK[:DATA]?
:TRACe:MATH:PEAK:POINts?
:TRACe:MATH:PEAK:SORT AMPLitude|FREQuency
PKDLMODE
Corresponding SCPI Command(s) Description/Comments
Sorts signal peaks by frequency or
amplitude, stores the results in the
destination trace, and returns the number
of peaks found.
Outputs the signal peaks to the controller,
sorted by frequency or by amplitude. The
sort mode is determined by the command
:TRACe:MATH:PEAK:SORT. The
commands
:CALCulate:MARKer:PEAK:EXCursion
and
:CALCulate:MARKer:PEAK:THReshold
are used to determine what is a signal
peak. To get the number of signals found
meeting the specified limits, use the query
:TRACe:MATH:PEAK:POINts.
Outputs the number of signal peaks
identified. The amplitude of the peaks can
then be queried with
:TRACe:MATH:PEAK[:DATA]?
Determines if the signals in the
:TRACe:MATH:PEAK[:DATA]? query
should be sorted by frequency or
amplitude.
Frequency sorts the identified peaks by
increasing frequency.
Selects the signal peaks that are displayed
in the peak table.