HP ESA-E Series Programmer's Manual page 389

Error Messages
201 to 799: Device-Specific Errors
606
Media is corrupt
A save was attempted to a corrupt device.
609
Media is not writable
A save was attempted to a read-only device.
605
Media is protected
A save was attempted to a write-protected device.
202
No peak found
No signal peak was found.
201
Option not installed
The desired operation cannot be performed because a
required option is not installed. For example, pressing
Source
analyzer will generate this error.
209
Preselector centering failed
An attempt to center the preselector failed.
704
Printer interface error
An error occurred while trying to print. Make sure the
printer is turned on and properly connected.
705
Printer Type is None
The current printer type is set to
operations are possible. Change the type in the
Setup
211
RBW limited to 1kHz when Span > 5MHz
In spans greater than 5 MHz, narrow (digital)
resolution bandwidths, below 1 kHz, are not available.
7-22
with no tracking generator installed in the
menu and try again.
, so no print
None
Print
Chapter 7