HP ESA-E Series Programmer's Manual page 297

HP 8590-Series
Analyzers
Command(s)
AMB
AMBPL
AMPCOR
AMPCOR (data) [SENSE:]CORRection:CSET[1]|2|3|4:DATA <freq>,
<rel_ampl>{,<freq>, <rel_ampl>}
AMPCOR
OFF/ON [:SENSe]:CORRection:CSET:ALL[:STATe] OFF|ON|0|1
[:SENSe]:CORRection:CSET[1]|2|3|4[:STATe]
OFF|ON|0|1
AMPCOR? [:SENSe]:CORRection:CSET[1]|2|3|4:DATA?
Corresponding SCPI Command(s) Description/Comments
Subtracts trace B from trace A and sends the
result to trace A during every sweep of the
spectrum analyzer.
Subtracts trace B from trace A, adds the
display line value to the difference, and sends
the result to trace A during every sweep of the
spectrum analyzer.
Applies amplitude correction at specified
frequencies.
Units and spaces are not allowed in SCPI. The
separator must be a comma (,) and the
terminator must be a semicolon (;). Frequency
and amplitude values must be entered in Hz
and dB.
The data format for the command and query is
always TDF P.
The HP 8590-Series analyzer returns data in
the format: -57.71, -58.12, -56.87. The HP ESA
analyzer returns data in the format:
-5.46380000E+001, -5.44410000E+001,
-5.47590000E+001. This is an example of IEEE
NR3 numeric response data.