HP ESA-E Series Programmer's Manual page 318

HP 8590-Series
Analyzers
Command(s)
INZ
INZ 75|50 [:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude]
<number>
INZ? [:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude]?
IP
:SYSTem:PRESet
KEYCLR
KEYCMD
KEYDEF
KEYENH
KEYEXC
Corresponding SCPI Command(s) Description/Comments
Specifies the value of input impedance
expected at the active input port.
Amplitude correction is applied to the display
data to adjust for the measurement situations
where the Unit Under Test has a different
impedance than the instrument 50 Ohm input
impedance.
The HP 8590-Series analyzer outputs data in
the format: 50. The HP ESA analyzer outputs
data in the format: +50.
Performs an instrument preset.
Clears softkeys 1 through 6.
Allows you to define the function and label of a
softkey. The softkey label is updated whenever
a softkey is pressed.
Assigns a label and user-defined function to a
softkey.
Allows you to activate inverse video mode or
underline part or all of the softkey label.
Executes the specified, previously defined
softkey.