HP ESA-E Series Programmer's Manual page 340

HP 8590-Series
Analyzers
Command(s)
PKPOS
PKRES
PKSORT
PKTBL
PKZMOK
PKZOOM
PLOT
PLTPRT
POWERON
:SYSTem:PON:TYPE PRESet|LAST
POWERON? :SYSTem:PON:TYPE?
Corresponding SCPI Command(s) Description/Comments
Returns a value, which is the index of the
maximum value in trace A, trace B, trace
C, or user-defined trace.
Returns the x-axis coordinates of the peaks
in the peak table.
Selects how the signal peaks listed in the
peak table are sorted: by decreasing
amplitude or by ascending frequency.
Turns the peak table on or off.
Returns a "0" if the peak zoom routine
(PKZOOM) found only the spectrum
analyzer local oscillator feedthrough,
otherwise a "1" is returned.
Automatically tunes the spectrum analyzer
to the signal with the highest amplitude
level while narrowing the frequency span
to the specified frequency span.
Initiates a plotter output of the screen data
to the remote interface.
Directs the plotter output to HP-IB, serial
or parallel ports.
Selects the state the spectrum analyzer
will be in when it is turned on: IP
(instrument preset) or LAST state.
The response is: PRESET or LAST.