HP ESA-E Series Programmer's Manual page 355

HP 8590-Series
Analyzers
Command(s)
STB
STDEV
STOR
SUB
:TRACe:MATH:SUBTract
<destination_trace>,<source_trace1>, <source_trace2>
SUM
SUMSQR
SWPCPL
SWPCPL SR|SA [:SENSe]:SWEep:TIME:AUTO:MODE SRESponse|
SANalyzer
SWPCPL? [:SENSe]:SWEep:TIME:AUTO:MODE?
Corresponding SCPI Command(s) Description/Comments
Returns to the controller the decimal
equivalent of the status byte.
Returns the standard deviation of the trace
amplitude in measurement units.
Stores data on a RAM card.
Subtracts source 2 from source 1, point by
point, and sends the difference to the
destination.
Performs the math expression and places
the result in the destination trace.
Returns the sum of the amplitudes of the
trace elements in measurement units.
Returns the sum of the squares of the
amplitude of each trace element.
Selects a stimulus-response (SR) or
spectrum analyzer (SA) auto-coupled
sweep time.
Specifies the type of automatic coupling for
the fastest sweep time at the current span.
This varies based on the current
measurement mode.
The HP 8590-Series analyzer returns SR or
SA. The HP ESA analyzer returns SRES or
SAN.