Table of Contents
Advertisement
Flat undertray sections and vehicle lifting
Lift the vehicle.
Refit the rear flat undertray section (
Runway type vehicle lift
Lower the vehicle to the ground.
Undo the indicated screws fastening the brackets
(AV
8251) to the subframe.
Remove the brackets
seats.
E3.12).
Lower the vehicle lift runways until the car is the
desired height from the ground.
Place the pads (C) at the rear vehicle lift points on
the runway safety extensions.
Loosen the screws (3) fastening the positioning
levers (6).
Tighten the positioning levers (6).
Turn the positioning levers (6) by 180°.
Visually check that the eccentric pins (7) are
positioned correctly to ensure that the anti-
tipping safety retainers
correctly from the relative brackets
attaching to the vehicle
Tighten the screws (3) fastening the positioning
levers (6).
Page 13 of 27
(AV
8251) from the relative
(AV
8183) withdraw
(AV
8251) for
Advertisement
Table of Contents
