Comtech EF Data CDM-710 Installation And Operation Manual page 268

CDM-710/L Broadcast Satellite Modem
Serial Interface Operation
Controller-to-Target
Instruction Code & Qualifier
Parameter
Type
Command Query
GBEI GIP= GIP?s
Management
IP Address
and Subnet
GBEI GMI= GMI?
Multicast IP
Address
GBEI Active GSA= GSA?
Stream
GBEI Source GSI= GSI?
IP Address
GBEI Stream GSM= GSM?
Mode
GBEI Primary GSP= GSP?
Stream
Number of
Arguments for
Command or
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Query
19 bytes Command or Query.
Sets or returns the CDI-70 GBEI Management IP Address and Subnet Mask in
the form sxxx.xxx.xxx.xxx.yy where:
s=2 (Interface Slot 2 only)
xxx.xxx.xxx.xxx=IP Address
yy=Subnet Mask
17 bytes Command or Query.
Sets or returns the CDI-70 GBEI Multicast Address in the form
smxxx.xxx.xxx.xxx, where:
s=2 (Interface Slot 2 only)
m=Multicast Stream (1 or 2)
xxx.xxx.xxx.xxx=IP Address
2 bytes Command or Query.
Sets or returns the CDI-70 GBEI Active Stream in the form sm, where:
s=2 (Interface Slot 2 only)
m=Active Multicast Stream (1 or 2)
17 bytes Command or Query.
Sets or returns the CDI-70 GBEI Source IP Address in the form
smxxx.xxx.xxx.xxx, where:
s=2 (Interface Slot 2 only)
m=Multicast Stream (1 or 2)
xxx.xxx.xxx.xxx=IP Address
2 bytes Command or Query.
Sets or returns the CDI-70 GBEI Stream Mode in the form sm, where:
s=2 (Interface Slot 2 only)
m=Mode, where 1=Single Stream, 2=Dual Stream (Redundancy Mode)
2 bytes Command or Query.
Sets or returns the CDI-70 GBEI Primary Stream in the form sm, where:
s=2 (Interface Slot 2 only)
m=Multicast Stream (1 or 2)
9–60
Description of Arguments
MN/CDM710.IOM
Revision 12
Target-to-Controller
(See Description of Arguments)
Response to Response to
Command Query
GIP= GIP=sxxx.xxx.xxx
GIP# .xxx.yy
GIP?
GIP*
GMI= GMI=smxxx.xxx.
GMI# xxx.xxx
GMI?
GMI*
GSA= GSA=sm
GSA#
GSA?
GSA*
GSI= GSI
GSI# =smxxx.xxx.xxx.
GSI? xxx
GSI*
GSM= GSM=sm
GSM#
GSM?
GSM*
GSP= GSP=sm
GSP#
GSP?
GSP*