Comtech EF Data CDM-710 Installation And Operation Manual page 138

CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(CONFIG:) Intfc1 ASI:  Rx  Frame
To enable the desired sync mode: Use the   arrow keys to select 188 or 204.
Press ENTER.
(CONFIG:) Intfc1 ASI:  Config
Use the   arrow keys to select Port or Bandwidth. Press ENTER.
(CONFIG:) Intfc1 ASI:  Config  Port
Use the   arrow keys to select J4 or J5. Press ENTER.
Also see (CONFIG:) AUX  1:1 Mode for redundancy operation.
(CONFIG:) Intfc1 ASI:  Config  Bandwidth
To select the loop bandwidth of the ASI input: Use the   arrow keys to select
Wide or Narrow. Press ENTER.
Terrestrial jitter sometimes increases when data is sent across the Public
Switched Telecom Network (PSTN). Wide corresponds to about 2 Hz and
Narrow is approximately 0.5 Hz. Normally, the Wide selection is
adequate, but when higher amounts of terrestrial jitter are present in the
incoming ASI data stream the Narrow setting will help reduce jitter.
Intfc1 ASI Rx Frame:
188 204
Intfc1 ASI CONFIG:
Port Bandwidth
Intfc1 ASI Port:
J4 J5
Intfc1 ASI Bandwidth:
Wide Narrow
7–32
MN/CDM710.IOM
Revision 12
(E)
(E)
(E)
(E)