Comtech EF Data CDM-710 Installation And Operation Manual page 266

CDM-710/L Broadcast Satellite Modem
Serial Interface Operation
Controller-to-Target
Instruction Code & Qualifier
Parameter
Type
Command Query
Faults and
Status
(continued)
Number of
Arguments for
Command or
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Query
D= SERDES Framer to FEC2
E=Reserved
F= MPEG transport stream error.
G=ASI Rx PLL Empty (Interface Slot 1)
H=ASI Rx PLL Full (Interface Slot 1)
I=ASI Rx PLL Lower Limit Reached (Interface Slot 1)
J=ASI Rx PLL Upper Limit Reached (Interface Slot 1)
K=Reserved
L=Reserved
M=Reserved
N=Reserved
O=Reserved
P=ASI Rx SERDES Error (Interface Slot 1)
Q=ASI Rx SERDES DCM Unlocked (Interface Slot 1)
R= Reserved
S= Reserved
T=HSSI Rx Buffer Underrun (Interface Slot 1)
U=HSSI Rx Buffer Overflow (Interface Slot 1)
V=Reserved
W=Reserved
X=Framer SERDES Rx Fault (Interface Slot 1)
Y=Framer SERDES Rx Fault (Interface Slot 2)
Z=Reserved
[=Reserved
d=New Faults where:
0=No new faults
1=New faults since last check
e=Configuration change where:
0=Unit configuration has not been changed
1=Unit configuration has been changed
2=Reserved
3=Gateway IP Address has been changed
NOTE: Typical for each parameter – Faults are listed in order of priority. While
multiple faults may exist, only the highest priority fault for that parameter is
returned.
9–58
Description of Arguments
MN/CDM710.IOM
Revision 12
Target-to-Controller
(See Description of Arguments)
Response to Response to
Command Query