Comtech EF Data CDM-710 Installation And Operation Manual page 180

CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(UTIL:) FAST  Cnfg  Demo Mode
The FAST Demo Mode enables all FAST options for a limited time. When
enabled, Demo Mode allows access to ALL CDM-710/L FAST options for 45 days.
Older units running earlier firmware versions allow Demo Mode for 604800
seconds (7 full days). Demo Mode may be turned on and off an unlimited
number of times until the available time has expired.
Use the   arrow keys to select Off or On. Press ENTER. The display indicates
the time remaining on the demo counter. The demo time may be paused either by
turning demo mode off, or by unplugging the unit. However, whenever the unit is
turned back on, the demo counter will resume.
(UTIL:) FAST  View
These screens display read-only status messages about each FAST or hardware
option and the installation status (Installed or Not Installed) for that option. Use
the  arrow key to browse through these screens. Press ENTER or CLEAR to
return to the previous menu.
This list is representative, and subject to change:
Option Number
(top line)
IF Modulator (for CDM-710 70/140 MHz units)
01
L-Band Mod (for CDM-710L L-Band units)
IF Demodulator (for CDM-710 70/140 MHz units)
02
L-Band Demod (for CDM-710L L-Band units)
03 FEC Slot 1
04 FEC Slot 2
05 Interface #1
06 GBEI Intf2
FAST Demo Mode: Off On
3888000 seconds remain
View Options: 01 ()
IF Modulator Installed
Description (bottom line)
7–74
MN/CDM710.IOM
Revision 12