Comtech EF Data CDM-710 Installation And Operation Manual page 270

CDM-710/L Broadcast Satellite Modem
Serial Interface Operation
Controller-to-Target
Instruction Code & Qualifier
Parameter
Type
Command Query
Gateway IP IPG= IPG?
Address
Interface N/A ITF?s
Type
Rx Link N/A LNK?
Margin
Local/Remote LRS= LRS?
Status
Unit MAC N/A MAC?
Address
Number of
Arguments for
Command or
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Query
15 bytes Command or Query.
Sets or returns the Gateway IP Address for the 10/100 BaseT 'J4 | Ethernet'
management port in the form xxx.xxx.xxx.xxx where:
xxx.xxx.xxx.xxx=IP Address
COMMAND EXAMPLE: <0001/IPA=010.006.030.002{CR}
2 bytes Query only.
Returns Interface Type in the form s, where:
s=Interface Slot 1 or 2
QUERY EXAMPLE: <0001/ITF?1{CR}
>0001/ITF=1x{CR}{LF} where x=active interface type:
0=CDI-40 ASI (Interface Slot 1 only)
1=CDI-70 GBEI (Interface Slot 2 only)
2=CDI-60 HSSI (Interface Slot 1 only)
4 bytes Query only.
Returns the value of the Link Margin in the form xx.x.
NOTE: Returns 00.0 if demod is unlocked.
1 byte Command or Query.
Sets or returns the Local/Remote operation in the form x, where:
0=Local
1=Serial
2=Reserved
3=Ethernet
4=Serial+Ethernet
COMMAND EXAMPLE: <0001/LRS=4 (sets Serial+Ethernet remote mode)
12 bytes Query only.
Returns the MAC address for the unit, in hexadecimal format, in the form
AABBCCDDEEFF.
EXAMPLE: <0001/MAC?{CR}
>0001/MAC=006B000D2A7{CR}{CR}{LF}
(The unit MAC Address is 00:06:B0:00:D2:A7)
9–62
Description of Arguments
MN/CDM710.IOM
Revision 12
Target-to-Controller
(See Description of Arguments)
Response to Response to
Command Query
IPG= IPG=xxx.xxx.xxx.
IPG? xxx
IPG*
IPG#
ITF? ITF=s
ITF*
ITF#
LNK? LNK=xx.x
LNK*
LNK#
LRS= LRS=x
LRS?
LRS*
LRS#
MAC? MAC=AABBCCDD
MAC* EEFF
MAC#