Comtech EF Data CDM-710 Installation And Operation Manual page 241

CDM-710/L Broadcast Satellite Modem
Serial Interface Operation
Controller-to-Target
Instruction Code & Qualifier
Parameter
Type
Command Query
Faults and
Status
(continued)
Number of
Arguments for
Command or
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Query
H=Framer Card Temperature
I=Modem Temperature
J=Cooling Fans
K=Interface Slot 1 Removed
L=Interface Slot 2 Removed
b=Tx Traffic Status where:
0=No faults
c=Rx Traffic Status where:
0=No faults
1=+1.5V Demod Power Supply Unit (Demodulator Card)
2=FPGA Load (Demodulator Card)
3=Demod Unlocked
4=DSNG Sync Error
5=FPGA Temperature (Demodulator Card)
6=Reserved
7=AGC Level Out of Range
8=Eb/No Limit Exceeded
9=Demodulator Synth 1 PLL
A=Demodulator Synth 2 PLL
B= SERDES Demod to Framer
C= SERDES Framer to FEC1
D= SERDES Framer to FEC2
E=Reserved
F= MPEG transport stream error.
G=ASI Rx PLL Empty (Interface Slot 1)
H=ASI Rx PLL Full (Interface Slot 1)
I=ASI Rx PLL Lower Limit Reached (Interface Slot 1)
J=ASI Rx PLL Upper Limit Reached (Interface Slot 1)
K=Reserved
L=Reserved
M=Reserved
N=Reserved
O=Reserved
P=ASI Rx SERDES Error (Interface Slot 1)
Q=ASI Rx SERDES DCM Unlocked (Interface Slot 1)
9–33
Description of Arguments
MN/CDM710.IOM
Revision 12
Target-to-Controller
(See Description of Arguments)
Response to Response to
Command Query